Replacing the dinette
The dinette had pretty much come out as one piece, so it wasn't terribly hard to just fit it back and screw it in. A couple of adjustments to the front edge had to be made, I think the new floor raised it about an inch. We put the table in to make sure everything still fit nicely.
Sorry for the quality of these pictures, but the sun outside was very bright!
I don't have foam cushions for this dinette, so I will have to either find some or buy some new, which I dread. Have you seen foam prices? Outrageous! I still have the foam from the small back dinette, I may be able to piece those together with this shorter foam pictured here I salvaged from a damaged truck camper.
Just in case black spray paint all around the outside wasn't enough, here's a spot on the table, too. Hopefully that'll clean off with a bit of stripper, I was going to leave the table as is, since it is in surprisingly good condition. The top laminate was a bit loose, so I pulled it off and just reglued it down.
